Here is the procedure I did:ģ) Press and hold the emergency override button.Īfter 15 seconds, the siren or horn will sound three (3) times.
So I tried the procedures steps listed below to re-program a remote transmitter for my car, somehow the system can learn the remote transmitter, but look like it does not save the new transmitter code in memory. But the car does not have any remote transmitter. I just bought a used Honda Accord 1997 which equiped with the Chapman security system with keyless entry system installed. Operate the functions of each transmitter in order to verify correct system operation Here are the instructions I used on my 1998 Operate the functions of each transmitter in order to verify correct system operation. Install the MALL PGM fuse into the fuse block. Repeat the previous step in order to program each additional transmitter. After approximately 14 seconds the BCM will chime a second time to confirm that the programming has been completed. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for approximately 14 seconds.Īfter approximately 7 seconds the BCM will chime once to confirm that synchronization has been completed. The BCM will chime in order to confirm that the programming mode has been entered. If the BCM has stored any DTCs, refer to Diagnostic System Check - Body Control System in Body Control System. The BCM may begin to chime and flash diagnostic trouble codes (DTCs). Turn the ignition to OFF, and then back to ACC within 1 second. The body control module (BCM) will perform the following in order to identify the type of BCM installed in the vehicle:įlash the seat belt indicator 1, 2, or 3 times. Insert the ignition key into the ignition lock cylinder. Remove the MALL PGM fuse from the fuse block. Remove the ignition key from the ignition lock cylinder.
This prevents the programming of the transmitters to the incorrect vehicle. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. Up to four transmitters can be programmed. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Just for the record here is the 2002 Grand Prix Procedure taken directly from the service manual.Īll transmitters which are to be recognized by the remote control door lock transmitter (RCDLR) must be programmed in a single programming sequence. Are you getting the conformation chimes? Let me know what is, or is not happening and maybe I can help you.
The procedure is basically the same for 97 and up Grand Prix's.
0 kommentar(er)
